| Processor
- Crestron MP2 Control and Audio/Video
Switch |
| |
CPU |
32-bit
Motorola 5407 ColdFireŽ Processor |
| |
Processing
Speed |
257
MIPS (Dhrystone 2.1 benchmark) |
| Memory |
| |
36
MB Total |
| Connectors |
| |
COM |
(2)
DB9 for RS-232/422/485 |
| |
RELAYS |
(4)
normally open, isolated relays; each relay
is rated 1A, 30VAC/DC; MOV arc suppression
across contacts for use with "real
world" loads |
| |
INPUT |
(4)
programmable digital/analog inputs digital
inputs rated for 0-24VDC, 20K ohms input
impedance, logic threshold 1.25VDC; analog
inputs rated for 0-10VDC, protected to
24VDC maximum, 20K ohms input impedance;
programmable 2K ohms pullup resistor (per
pin, software reference to GND or closure
to GND) |
| |
IR
ports |
4
programmable simultaneous outputs for IR,
TTL Level RS-232 or serial interface;
signal (ws) and ground (G) pins; infrared
output up to 1.2MHz with individual UART
per port allowing simultaneous firing of
all ports |
| |
IR
Receiver |
3-position
mini-phoenix for use with CNXRMIRD. Used
to recognize RC-5 and Sanyo IR remote
controls. |
| |
Computer
Port |
1
RS-232 port,9-Pin DB9 for programming a PC |
| |
Cresnet
Port |
1
4-Pin male connector |
| |
Power |
1-jack
accepts 24VDC from PW-2420RU power supply
(included), passes power through to
CresNET port |
| Video
Switcher - Crestron MP2 Control and Audio/Video
Switch |
| |
6BNC
connectors implement a 4 x 2 composite
video crosspoint or can be used as a 2 x 1
S-Video crosspoint (Y/C). All inputs have
video sensors built-in and are 75 ohm
terminated. Outputs are designed to drive
75 ohm devices |
| Audio
Switcher |
| |
8
Mini screw terminal connectors implement a
7 x 1 stereo audio crosspoint supporting
balanced and unbalanced audio in and out.
A built-in stereo volume, bass and treble
control is included on the output as well
as a 6-Band parametric equalizer with user
definable presets for all input sources. |
| Reset
Buttons |
| |
HW-R |
Performs
physical reset of system |
| |
SW-R |
Restarts
SIMPL program |
| LED
Indicators |
| |
PWR |
Green
LED, indicates power supplied to the unit |
| |
NET |
Yellow
LED, indicates activity within the system |
| |
ERR |
Red
LED, indicates an error message is
available from the software feature
buttons |
| Power
Requirements -
Crestron MP2 Control and Audio/Video
Switch |
| |
External
24VDC, 2.0A2, 24W+ power jack or Cresnet
connector; PW-2410RU Power Supply included |
